|
Re: What Did You Do With Your Truck Today ?
Quote:
Originally Posted by Dan in Pasadena
No schit, huh?!
I was quoted $240 for just ONE 4" deep I beam, 8 ft long. I found these beams 10" deep, 4" flanges, 25 ft long in Craigslist for only $100!! Had to drop $40 for a used cheapo Harbor Freight portaband to cut them in half - even at 12+ ft they were a stretch to get home on my dually!
Had to go into the war zone inner city to get them too but it was quite a savings.
Posted via Mobile Device
|
Some poor contractor is trying to figure out where his steel for his project went! I did the same with my garage with the laminated beams. Got mis-cut one 6" deeper and 2" wider than what I needed for 25% of new cost.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread
1964 Chevelle Malibu w/ 355-350TH (daily driver)
Helpful AD and TF Manual Site Old Car Manual Project
|