View Single Post
Old 06-07-2012, 11:17 PM   #8
Wrenchbender Ret
Registered User
 
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,229
Re: Timing question..

There is a screw under the dist that loosen s up to turn the dist in the vacuum advance clamp. Loosen the bolt holding the the dist down & set the scale on 0. This is called the octane selecter. Set the timing by turning the dist & tighten the clamp. A final adjustment can be made withe octane selecter.
Wrenchbender Ret is offline   Reply With Quote