|
Re: Dual headlight conversion
I did it years ago when I wanted the dual headlight look.
The one problem I ran into was I drilled the holes for the high beam adjusters (Lower Bulb) and installed nuts on both sides of the core support. It made it a pain to adjusted the High Beams , but with the bezels and turn signals from the dual headlight setup it looked factory.
The Lower bulb bucket will semi fit in the old turn signal hole but its not pretty.
I don't know how rare the dual supports are now , but if I had it to do over I would swap the Core Support.
If you decide to weld some parts together I have a support I can send you pics of or measurements for reference.
Desert
|