The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

oldspowered67C10 · 07-06-2012, 11:59 PM

If I remember correctly on a th350, drop the pan, drive the pin out that holds the shift rod to the detent plate and slide the shaft out twoards the outside. Remove the old seal and drive the new one in with a appropriate sized socket. I also think there is a o-ring on the shaft, replace it also. All in all a easy job, good luck.

07-06-2012, 11:59 PM	#2
oldspowered67C10 Registered User Join Date: Jan 2006 Location: Cherry Valley,Ca Posts: 468	Re: TH350 OOzing If I remember correctly on a th350, drop the pan, drive the pin out that holds the shift rod to the detent plate and slide the shaft out twoards the outside. Remove the old seal and drive the new one in with a appropriate sized socket. I also think there is a o-ring on the shaft, replace it also. All in all a easy job, good luck.