The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - does anyone run 1/2 inch push fittings on 200 psi?

texastrendz · 07-08-2012, 11:17 AM

NPT is measured I.D. The inside dimenson of the fittings you will need should measure 1/2 inch. If i remember correctly the O.D. is roughly 3/4 inch on 1/2 NPT fittings.

07-08-2012, 11:17 AM	#19
texastrendz Registered User Join Date: Jan 2008 Location: HOUSTON TX Posts: 1,161	Re: does anyone run 1/2 inch push fittings on 200 psi? NPT is measured I.D. The inside dimenson of the fittings you will need should measure 1/2 inch. If i remember correctly the O.D. is roughly 3/4 inch on 1/2 NPT fittings.