Quote:
Originally Posted by Porterbuilt Street Rods
Send me your e-mail address and we will send you a set of instructions.
There is almost an inch and a half difference in the rear wheel well opening center-line on the Fleet vs. Step side trucks. The stepper is forward when compared to the fleet. We also make a notch specifically for the step side beds now, and If I recall correctly, you have a step side bed... and we sent you the new step side notch. 
You should have left your trailing arm cross-member in the forward most mounting position so that the axle lands in the center of the notch/center of the wheel well opening. Should be a simple fix. Go ahead and give us a call with any questions so we can get ya fixed up.
Nate |
Thanks for the response nate. I did already get the email with instructions. So the cross member should be mounted as far forward (towards front of truck) for the stepside to center? I guess my screw up was mounting it towards the rear of the truck per instructions but that must be for fleet side. Pretty quick fix if that is the case.