|
Re: how to
I'm going to assume you're trying to bleed the whole system and not just the radiator....
1 - fill radiator
2 - start engine and turn on the heater
3 - get engine up to temp to open the thermostat
4 - when the level drops in the radiator, add more fluid
Keep adding fluid until the level stops dropping - wait a little while each time you add fluid.
Put the cap back on before shutting off the engine, and then add fluid to the reserve tank if you have one.
Once the engine cools off totally, check the level in the radiator and reserve tank again and you should be good to go.
|