The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**1project2many** · 08-15-2012, 10:37 PM

Pulled all the replacement pcm wires out of the computer connectors to run them through the firewall grommet from the old harness then re-installed all the wires. Laid out the harness on it's new path and started connecting engine wiring. Actually had the Smoke Ram intake and 454 TBI setup on the bench considering swapping intakes but decided to stay with the Crossfire intake due to time constraints. But I am wiring the TPS, MAP, and IAC through separate plugs that I can disconnect when I replace the intake. It will make it easier to install the new connectors without modifying the harness again.

08-15-2012, 10:37 PM	#1116
1project2many Senior Member Join Date: Mar 2012 Location: Lakes Region NH Posts: 3,217	Re: What Did You Do With Your Truck Today ? Pulled all the replacement pcm wires out of the computer connectors to run them through the firewall grommet from the old harness then re-installed all the wires. Laid out the harness on it's new path and started connecting engine wiring. Actually had the Smoke Ram intake and 454 TBI setup on the bench considering swapping intakes but decided to stay with the Crossfire intake due to time constraints. But I am wiring the TPS, MAP, and IAC through separate plugs that I can disconnect when I replace the intake. It will make it easier to install the new connectors without modifying the harness again.