Quote:
Originally Posted by arturo7
Thanks, O. You wouldn't happen to have a sketch of that fabricated mount, would ya? Or is that something that should be done for each specific installation?
|
I can get some measurements and post them BUT my truck is 4wd. I located mine by installing the front axle, installing the engine SB, auto trans and transfer case using the stock 74 from drive line (pita to modify). I checked to make sure I had clearance for the distributor and heads then made up the mount. It looks close to where the stock one lands. I made a template out of plywood, you can do the same and move it around. Nice thing is if you keep the radiator in the stock 6 location there is plenty of room to move it forward a little. Watch that the pan doesnt interfere with the axle or tie rod.
Mr. 48, I had a mount like that once and was told it came out of an early Corvette.