[CC69Rat]

Very much appreciated fellas. Dad is good friends with Mike Hudlow, you may have heard of Hudlow Axle (?)

With these wheels having 6" BS, I might be slightly too far inboard. This is very much fixable with a .25" wafer spacer behind the wheel. If it takes it, I'll get Mike to cut some specific for the rear end width after I get the discs on it, etc. I'll make it sit nicely in the wheel well. I'd rather it be 6"BS than 5". I'd rather it tuck under the wheel lip.

IF I need to, I can sell my 295/45/20 and go back to 295/40 for slightly less section width I just like the look of slightly more sidewall .. but we'll see how it goes. I could also offset the wood in the bed a little if I needed to .. just not sure how much room there is between the inner fender edge and the tire on the typical 295/40 and 5.5" BS setup? Do I have any room there at all?