[jonzcustomshop]

Originally Posted by jonzcustomshop

more done... setting the engine crossmember have to trim, and re-weld the tops of the motor mount brackets, the sway bar crossmember is kind of sitting where it fits, it lined up with the sway bar perfect, however it is 2 inches farther away from the front spring perch than it was on the 88 sub.

Anyone think there is a problem with that? could it be because of the lift?, and should I wait to place the sway bar mounts until after the engine and front clip is on??
the rear mounts went on easier than I thought they would, I had to heat the frame rail a little and massage it with a B.F.H. where the provisions for the ebrake were, but they fit nice after that.

any suggestions?????