View Single Post
Old 10-01-2012, 05:47 PM   #3
Fenhold
Registered User
 
Join Date: Feb 2009
Location: La Crescenta, Ca
Posts: 88
Re: Fuel filler patch

With the piece cut out I set it in place with the magnets and began the slow tedious task of tacking it in place. I took care to make sure the patch was perfectly level with the original panel in each spot I welded. The magnets held incredibly well and I simply slid them around to hold each new spot. They will last a while as long as you don't get the arc right up next to them or they will loose strength. I went slowly back and forth bumping where needed to keep it flush.
Attached Images
     
Fenhold is offline   Reply With Quote