Quote:
Originally Posted by 70K10Hunter
could you post a closeup of the model compressor that is mounted on your setup? maybe a belt number also?
Thanks
|
They are just painted silver. They are actually very good heads. World Products Torquer Srs.
Model on compressor= SD5 "Standard Vintage Air Model". Make sure you specify you want the serpentine pulley. This was originally a v-belt, but I swapped it over to serp. Getting just the pulley after the fact is a major PITA. I got lucky from another board member.
I also put a new idle pulley on while I was at it (picture/part # in photo below). It's cheaper to buy the pulley/bearing assembly than just the bearing. About $23 at Napa