The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

sbrban · 10-17-2003, 12:31 AM

The drillbit from napa is called a blair cutter made by blair ind. they work good but be careful not to angle the bit while drilling, it will break and "walk" across the panel your'e working on. If you are drilling a lot of spot welds get the wivco"spot eze" brand bits like what eastwood sells they last alot longer and you can drill in closer areas. Of course you could just buy a spot weld drill and avoid all the effort-work excellent-a little testy though, mine was $500.

10-17-2003, 12:31 AM	#16
sbrban Registered User Join Date: Sep 2002 Location: Iowa Posts: 236	The drillbit from napa is called a blair cutter made by blair ind. they work good but be careful not to angle the bit while drilling, it will break and "walk" across the panel your'e working on. If you are drilling a lot of spot welds get the wivco"spot eze" brand bits like what eastwood sells they last alot longer and you can drill in closer areas. Of course you could just buy a spot weld drill and avoid all the effort-work excellent-a little testy though, mine was $500. __________________ you never have too many suburbans.... Last edited by sbrban; 10-17-2003 at 12:48 AM.