The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*72longbed* · 10-29-2012, 07:08 PM

Looking for a good front driveshaft that would be 28.5" long with the slip-joint in the middle of it's travel. This would be the center of U-joint cap to center of farthest U-joint cap. Probably would be 27" fully compressed and 30" fully extended.

Needs to fit a NP205 transfer case with a yoke and the double cardan joint at that end, and a Dana 44 yoke other end.

I have one that's been totally rebuilt that's 28.5" fully compressed, and 31.5" fully extended. Just put a lot of money into it, all parts replaced and balanced, like new condition, will trade for value.

Thanks.

72longbed

10-29-2012, 07:08 PM	#1
72longbed Account Suspended Join Date: Jun 2003 Location: PA Posts: 1,411	WTB Front Driveshaft for 72 K20 .... Looking for a good front driveshaft that would be 28.5" long with the slip-joint in the middle of it's travel. This would be the center of U-joint cap to center of farthest U-joint cap. Probably would be 27" fully compressed and 30" fully extended. Needs to fit a NP205 transfer case with a yoke and the double cardan joint at that end, and a Dana 44 yoke other end. I have one that's been totally rebuilt that's 28.5" fully compressed, and 31.5" fully extended. Just put a lot of money into it, all parts replaced and balanced, like new condition, will trade for value. Thanks. 72longbed