|
Re: PO has me PO'd
Relocated my pcv valve to the rear of the aftermarket vc, more direct line to the intake. Bored hole out to 15/16" using a deming drill ( reduced shank to fit in my 1/2" chuck). Bit of a struggle to get the grommet over both pieces, since vc was thicker then oem.
Next will drill both pieces, oem diffuser and vc, and use a countersunk pop rivet to hold in place. Grommet alone holds well, but i dont want to take the chance and have it rotate with vibrations
20121031_130644 by jarosaj, on Flickr
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 11-01-2012 at 11:02 PM.
|