The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Livrat · 11-01-2012, 11:38 AM

Nick,
About the only way I know if is to cut holes in the top on the inside above each one, drill out the rivets holding the nut plates, manufacture new nut plates, rivet them back in and replace the pieces you cut out. (when repairing the holes you cut remember that it is not fiberglass but is SMC)

11-01-2012, 11:38 AM	#2
Livrat Member #1049 Join Date: Jun 2000 Location: Troy Montana Posts: 3,940	Re: Double wall bolt holes..... Nick, About the only way I know if is to cut holes in the top on the inside above each one, drill out the rivets holding the nut plates, manufacture new nut plates, rivet them back in and replace the pieces you cut out. (when repairing the holes you cut remember that it is not fiberglass but is SMC)