The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - How To - 3/4 Ton

LostMy65 · 11-06-2012, 10:48 PM

I don't want to be doing this from under the truck, so I set-up kind of a jig to line everything on the Eaton up.
I nailed 2x6's to my shop floor so they won't budge.
You could nail yours to a piece of Plywood.
I traced the Eaton's Trailing arm perches U-Bolt holes.
Then I will use this for getting CaptainFab's new Perches lined up on Corp 14-Bolt to match the Eaton perch location.

.

.

11-06-2012, 10:48 PM	#2
LostMy65 But Found Her 25yrs Later! Join Date: Oct 2010 Location: Oregon City, Oregon Posts: 10,530	Re: How To - 3/4 Ton - Converting to a 14bolt I don't want to be doing this from under the truck, so I set-up kind of a jig to line everything on the Eaton up. I nailed 2x6's to my shop floor so they won't budge. You could nail yours to a piece of Plywood. I traced the Eaton's Trailing arm perches U-Bolt holes. Then I will use this for getting CaptainFab's new Perches lined up on Corp 14-Bolt to match the Eaton perch location. . . __________________ I lost my 65 - Found it 25 years later: http://67-72chevytrucks.com/vboard/s...d.php?t=426650 66 C20 Service Truck: http://67-72chevytrucks.com/vboard/s...d.php?t=428035 Last edited by LostMy65; 11-06-2012 at 10:54 PM.