The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**jocko** · 11-26-2012, 09:59 PM

Should work no problem. For reference, I used my stock 3-speed trans bell housing when I swapped in my T5 and I used an 11" Astro Van clutch and it all fit fine. So I think you're good to go. 3 and 4-speeds should have the same i/p shaft length and mounting bolt pattern, etc, so all you really need to do is make sure the spline count is the same (or, if it's not, get a new clutch disk of same diameter - or a clutch/pressure plate combo with correct spline count)

11-26-2012, 09:59 PM	#2
jocko Senior Member Join Date: Oct 2009 Location: Godley, TX Posts: 17,998	Re: Transmission bell housing question Should work no problem. For reference, I used my stock 3-speed trans bell housing when I swapped in my T5 and I used an 11" Astro Van clutch and it all fit fine. So I think you're good to go. 3 and 4-speeds should have the same i/p shaft length and mounting bolt pattern, etc, so all you really need to do is make sure the spline count is the same (or, if it's not, get a new clutch disk of same diameter - or a clutch/pressure plate combo with correct spline count)