Ok. weekend update...
New crossmember for the trans/transfer case... boxed mounting plates to fit in the frame... I'm having a bracket cut on the water jet that will be bolted to the trans and welded to the crossmember...
Fox shocks hanging off the factory mounts.... I'll weld the lower mounts when the axle is centerd and pinion angle is set.
Here is the center console. I didn't really do anything to it this weekend other then take a pic. The very front still needs to be bent down. I have a hand e-brake to go in the center.... I just ordered some cable shifters from NWFab....
This is a set up for a doubler, I'll only have two shifters
the last pic is the CaptainFab booster mount and my new wire "harness" for the brake lights. I used a 90* fitting from home depot and I'm running 14awg 6 wire trailer wiring. I will be doing something custom with the rear lights...