|
Re: HELP with gear install
As always, I recommend against doing this yourself. Pay a Professional and get a warranty.
This is a very precision operation and must be respected as such. It requires special tools and patience. "Close" is NOT good enough, if it is not perfect, it will fail in some way. Noise is the bare minimum and catastrophic is very possible too, and it will definitely cost more to repair it after a failure than to pay it up-front.
BTW, for a Dana60, you do need an extra tool known as a case-spreader to get the carrier in/out with the correct bearing pre-load.
__________________
You can review the site's rules here.
Quote:
Originally Posted by Longhorn Man
As for reading directions...
The directions are nothing but another man's opinion.
|
Learn from the mistakes of others, you won't live long enough to make them all yourself...
Bad planning on your part does not necessarily constitute an instant emergency on my part....
The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|