View Single Post
Old 12-11-2012, 12:04 PM   #8
hyatt
Registered User
 
Join Date: Dec 2012
Location: sparta tennessee
Posts: 345
Re: Rear axle identification and driveshaft?

slide your yoke into the trans up to point that it has been running You can tell by rust on unused part of yoke Take a tape and measure from center of ujoint to center of ujoint area in rearend yoke Measure distance across rear yoke and go to parts store and get a ujoint to fit the rear Go to a napa or a major store not autozone or those types where they have people that can look up things without an application When you get a ujoint and the lenth between ft and rear any drive shop can cut you what you need
hyatt is offline   Reply With Quote