OK. Well I feel a little silly....
I went to test the Raceline wheel on the passenger side and it fit, but barely. So close that I went and assembled the driver side (I hadn't tried this before.) I tride to mount the Raceline wheel and it wouldn't fit over the wheel studs. The problem was I upgraded to 5/8" wheel studs and holes in the rim was too small. It had no allowance for being 27+ years old and slightly off center. So I grabbed the Hummer rim and .. TA DA... it fit the driver side, no problem.... 1/16" celarance between the caliper and rim.... So now I was thinking, what the hell is wrong with the other side....
I disassembled the passenger side brakes, then re-assembled making sure everything was aligned. There is a small amount of adjustment/play in the hole that the caliper mounting bolt goes through. I test the Hummer wheel again, and IT FIT.... again only 1/16" clearance, but it clears... as long as there is no deflection in my braket, I should be fine...
Another note about the Raceline wheels. You have to use aftermarket slpined lug nuts. The fit was so tight that you couldn't even get a thin wall socket on the lugnut. Now that may be beacuse I upgraded to 5/8 wheel studs and the OD of the larger lugnut take up more space, but just and FYI.
