The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Tx Firefighter · 12-26-2012, 05:26 PM

You said you pressed the pulley on. Did you press the pulley on or pull it on with a threaded installer of some fashion ? If you literally applied pressure to the pulley until it slid onto the shaft and seated, I can see a problem.

Barring that, it's usually aerated fluid. Sometimes it even takes over night to get it to settle out regardless of how much you cycle the system.

12-26-2012, 05:26 PM	#3
Tx Firefighter Watch out for your cornhole ! Join Date: Jun 2003 Location: Azle, Texas Posts: 14,162	Re: Power Steering Problem You said you pressed the pulley on. Did you press the pulley on or pull it on with a threaded installer of some fashion ? If you literally applied pressure to the pulley until it slid onto the shaft and seated, I can see a problem. Barring that, it's usually aerated fluid. Sometimes it even takes over night to get it to settle out regardless of how much you cycle the system.