|
Re: Leadfoots build thread
It does fit under the low hump, but not by much, I had to tap down the seam where the firewall and toe board meet a bit but this may have been because my truck has a whole front frame clip from a 73-87 truck not just the cross member. I think the engine may sit a little higher than stock, The shift tower on the tranny stuck up thru the floor a couple inches also making the shifter look a little weird, Yours may fit no mods required. Then again maybe not. The reason I went with the high hump is because the floor in my truck was destroyed by the previous owner with an air hammer, the hump was split down the sides and beat down so a different seat would fit. hope this helps, I do have several pics of this thing installed if you need them.
|