The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**crossy** · 11-02-2003, 10:02 AM

Chris, i'm not saying they don't make it but I have not seen a spacer. I made up a few block off plates out of 1/4" alum. and may have an extra one here. If you use a new gasket as a template you could easily make a spacer from 1/2" thick alum. if thats enough. Alum cuts pretty easy. if you get in a jam and are not in a hurry. i may be able to make one up at work but i never know when I'm going to get the time. lasr week i had plenty of time! .also alum can get pretty scarce there because of the G-jobs:-) .
The choke thingy you need is Edelbrock # 8901.
DAVE

11-02-2003, 10:02 AM	#2
crossy Oh,you can't buy that new Join Date: Apr 2000 Location: Pennsville,N.J. 08070, USA Posts: 2,042	Chris, i'm not saying they don't make it but I have not seen a spacer. I made up a few block off plates out of 1/4" alum. and may have an extra one here. If you use a new gasket as a template you could easily make a spacer from 1/2" thick alum. if thats enough. Alum cuts pretty easy. if you get in a jam and are not in a hurry. i may be able to make one up at work but i never know when I'm going to get the time. lasr week i had plenty of time! .also alum can get pretty scarce there because of the G-jobs:-) . The choke thingy you need is Edelbrock # 8901. DAVE __________________ "been there, done that, ruined the T-shirt". 2007 LBZ GMC Sierra, ECSB 2006 LM7 RCSB Silverado 98 Vortec project. 94,3500,6.5L 4L80 81 SWB GMC POS finally gone 73 Pinto, stock, w/CragarSS's-eww 84,C10 SWB-Yella,stock 86 K10 SWB-Red, hopped up 305,4/S LOTS of Cummins trucks.