|
Re: Ball Joint, tips advice?
ok, got it apart finally.
For some reason there was two spindle nuts. The round hole thing was a plate ontop of the spindle nut????
So over all things that are damaged that I didnt plan on...
outer section of axle shaft
the bolt on hub thing( I have a spare though)
spindle nut
axle snap ring
the locking hub assy
I expected to replace..
all bearings
bearing seal
ball joints
longhair. The only time I used a slide hammer was to get the bearing out thats in the spindle "cone" thing. Not sure whats its really called.
|