View Single Post
Old 02-25-2013, 09:45 PM   #8
Olive1970
Registered User
 
Olive1970's Avatar
 
Join Date: Dec 2012
Location: Dorr MI
Posts: 176
Re: '67 C20 Rochester 2G carb question

Quote:
Originally Posted by Trevlar View Post
Yes Sir. Aluminum, with approximately 3/16" triangle cut off one corner that sits against the bottom of float bowl, with the cut side aligned with the 'slot' in the accel.pump housing. That is the orientation that it was when I removed it...sound right?
Sounds right to me bud. Just make sure you put it right back in when putting the carb back together...not like I have been there before

Did you end up replacing the pump too?
__________________
Gary

Slowly looking for my next 67-72 truck
Olive1970 is offline   Reply With Quote