The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Andy4639 · 02-27-2013, 05:49 PM

Not as sharp but it has been sitting in the glove box now for over 20 years like this. I never finished installing it. I may have to finish it up after reading this and seeing the pictures.
The red light and switch are wired up to jumper the ADL connector to read the engine codes by the light flashing.

02-27-2013, 05:49 PM	#6
Andy4639 Old member Join Date: Jan 2002 Location: Liberty, & Garden City S.C. , U.S. Posts: 19,945	Re: mold for my glovebox pix Not as sharp but it has been sitting in the glove box now for over 20 years like this. I never finished installing it. I may have to finish it up after reading this and seeing the pictures. The red light and switch are wired up to jumper the ADL connector to read the engine codes by the light flashing. Attached Images __________________ 1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs.