The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PBFAB.COM · 03-18-2013, 01:16 PM

One thing that we have found, is that once you put a virgin line into a PTC fitting it will put a little barb/scratch on the line. If you remove the line and reinsert it into the PTC without trimming off the end section of the line so it is fresh and smooth, it will usually cause a small leak.

Make sure if you remove the line, you trim off about 1/4" of the line before you reinsert it.

Nate

03-18-2013, 01:16 PM	#6
PBFAB.COM Senior Member Join Date: Dec 2003 Location: Mesa,Az Posts: 3,981	Re: Air suspension push in fittings issues One thing that we have found, is that once you put a virgin line into a PTC fitting it will put a little barb/scratch on the line. If you remove the line and reinsert it into the PTC without trimming off the end section of the line so it is fresh and smooth, it will usually cause a small leak. Make sure if you remove the line, you trim off about 1/4" of the line before you reinsert it. Nate __________________ www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003!