Quote:
Originally Posted by Porterbuilt Street Rods
One thing that we have found, is that once you put a virgin line into a PTC fitting it will put a little barb/scratch on the line. If you remove the line and reinsert it into the PTC without trimming off the end section of the line so it is fresh and smooth, it will usually cause a small leak.
Make sure if you remove the line, you trim off about 1/4" of the line before you reinsert it.
Nate
|
This makes sense and why one side started leaking after rerouting the line.
I will try this on the front once I get the rear end back together... (doing an axle shaft swap at the moment to get the 5 lug pattern)
Will let you guys know what happens