Quote:
Originally Posted by HOTFUN
Either you have placed a spacer in front of the WP hub and behind the cast 3 groove water pump pulley or the new water pump hub was not pressed on the shaft far enough which I am betting it isn't. You could measure the the hub face surface distance to the pump casting and compare that to the original water pump hub distance or maybe someone here has a correct waterpump for measurement to compare. Then you will have to remove the wp rear cover and press the hub down the required distance with the the back of the shaft held in the press. The pulley just needs to go on further so the ac belt can ride in the outer water pump groove,to the second crank pulley groove, and over ac compressor.
|
Hey Mark, any pics of your 16K 74, those trucks are killer.