The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Tukn22z · 03-22-2013, 04:24 PM

So i installed new bushings and shafts in my upper control arms and as far as the shafts being centered, one control arm was off .070" and the other was .072" off center. what i did was indicate each shaft hole and used an edge finder and bumped up to the side of the arm. Is this something to be concerned about? I really dont want to take these apart again.

03-22-2013, 04:24 PM	#1
Tukn22z Registered User Join Date: May 2005 Location: michigan Posts: 9	Control arm shaft centering tolerances So i installed new bushings and shafts in my upper control arms and as far as the shafts being centered, one control arm was off .070" and the other was .072" off center. what i did was indicate each shaft hole and used an edge finder and bumped up to the side of the arm. Is this something to be concerned about? I really dont want to take these apart again.