View Single Post
Old 04-02-2013, 08:34 AM   #4
SCOTI
Registered User
 
SCOTI's Avatar
 
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,136
Re: Which frontdrop shocks for a 5/7 static drop

Quote:
Originally Posted by 54Caddy View Post
Scoti at one time I read a post of yours about the shocks you ran on your old orange truck, what were they? If I remember you we're running factory shocks from a different vehicle.
Posted via Mobile Device
That truck was between 5-6" front drop w/spindles & cut OE sbc coils. I used off the shelf replacement shocks up front by relocating the upper mount approx 1.5" higher up on the frame rail.

The rear was approx 8" drop w/the towing/HD leaf option utilizing 8-leaf spring pack. I installed a flip kit, drop shackles, & shock extenders. The extenders still did not allow enough travel so I utilized some shocks that were spec'd for the front on a 73-87 4x4 GM truck/burb/blazer. The upper bolt was a direct swap. the lower bolt required a different bushing combo because the bolt on the shock was smaller than the mount hole on the truck.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG

Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....

Cubic inches is like Indiana Jones with a cheap pistol.
SCOTI is offline   Reply With Quote