The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MrShelley · 11-17-2003, 11:03 PM

Nothing to drilling the steam holes. Use a gasket as a template and drill away. There are six holes per head (two between each cylinder). The holes are 1/8". The holes on the intake side are 30 degrees. The three remaining holes are straight.

Hope this helps.

11-17-2003, 11:03 PM	#3
MrShelley Too Many Clubs Club Join Date: Jul 2003 Location: Kilgore, Texas Posts: 443	Nothing to drilling the steam holes. Use a gasket as a template and drill away. There are six holes per head (two between each cylinder). The holes are 1/8". The holes on the intake side are 30 degrees. The three remaining holes are straight. Hope this helps.