The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - HELP!!! upper/lower control arm info needed

**First c10** · 04-17-2013, 12:56 AM

I know this is an old thread but the # 10 looks like the washer that it flat on one side and curved on the other. The curved side goes towards the shaft if your shaft uses them. The 73-87 shafts I am installing use this shaft and washer. I am going to us the 2 piece style first than shims and then the #10 washer then the shaft. Hope it works. Oh also my shaft nuts were 3/4".
Good luck
Posted via Mobile Device

04-17-2013, 12:56 AM	#15
First c10 Registered User Join Date: Dec 2012 Location: Los Banos CA Posts: 2,706	Re: HELP!!! upper/lower control arm info needed I know this is an old thread but the # 10 looks like the washer that it flat on one side and curved on the other. The curved side goes towards the shaft if your shaft uses them. The 73-87 shafts I am installing use this shaft and washer. I am going to us the 2 piece style first than shims and then the #10 washer then the shaft. Hope it works. Oh also my shaft nuts were 3/4". Good luck Posted via Mobile Device __________________ 1956 Chevy Bel Air 2 door 1956 Chevy 210 4 Door 1970 K20 LWB project the Hulk build w/Supercharged 4.8L-ly2/4L60E HULK BUILD 1970 C10 Yellow/White Deluxe LWB w/ 5.3L-LC9/6L80E 1968 K10 LWB Dark green my son calls it "THE HULK Jr"HULK JR SOLD GO GO!!!