The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - switching from old heads to really old heads

*cranknut67* · 11-19-2003, 03:47 AM

I just got the new heads in casting #3782461 cut for 1.6 2.02 valves ( 3 angle job fully tricked out ), and I noticed that they have no accessory holes. I now need the whole dang setup from an older non head mounted block. and I plan to set up the heads this weekend - anybody in az have a whole setup pullies and all, to sell? I have the power steering bracket - ordered it online tonite. still need the pullies for the water pump crank ( 3 groove I think) and the alternator bracket. - I can allready tell that this is going to be a pain in the butt

confused:

11-19-2003, 03:47 AM	#1
cranknut67 Account Suspended Join Date: Jun 2003 Posts: 139	switching from old heads to really old heads - need pully advice I just got the new heads in casting #3782461 cut for 1.6 2.02 valves ( 3 angle job fully tricked out ), and I noticed that they have no accessory holes. I now need the whole dang setup from an older non head mounted block. and I plan to set up the heads this weekend - anybody in az have a whole setup pullies and all, to sell? I have the power steering bracket - ordered it online tonite. still need the pullies for the water pump crank ( 3 groove I think) and the alternator bracket. - I can allready tell that this is going to be a pain in the buttconfused: