Quote:
Originally Posted by lolife99
Clean, clean, clean!^^^
|
Thanks Keith, I guess I'm going to have to pay more attention to the details so I don't have to go through this again. It's all Jeff's fault, his truck is SO darn nice, I am going to have to put in some elbow grease to shine this turd!
Quote:
Originally Posted by 68 Four on the Floor
Gotta love rear discs on the old c10s
Posted via Mobile Device
|
They look good and work great too!
Quote:
Originally Posted by shawno72
looks super clean Buck!!
|
Thanks Shawn
Quote:
Originally Posted by shearjs
Looks great Buck. Hopefully that fixed your vibration issues. You had me a little worried that my trans tailshaft might be sitting a little too low.
|
I still may have some drive line alignment issues, but I hope the wheel balance takes care of most of it!
Quote:
Originally Posted by knomadd
Looks nice! Glad you got the vibration figured out.
I do have one question for you... Are you going to sand off the paint on the braking surface before you drive it? I would think that paint will gum up your pads.
Posted via Mobile Device
|
I'm going to let the pads wear off the paint to make a nice clean line. The pads will be fine. In the past I was taught to paint fresh pads to help prevent squealing. I'll let you all know how it turns out!