[markeb01]

What an impressive build, first time I've seen it. You are really moving along at a good pace, a great deal of work accomplished in a relatively short time. I also love the seat, that turned out beautifully. The engine/chassis looks fantastic.

It's not surprising to see the old 283/327 engines look really cruddy inside. Prior to introduction of the PCV (Positive Crankcase Ventilation) valve, the road draft tube at the back of the engine block was the only method to remove damaging fumes from inside the engine. The problem was, it didn't ventilate the engine very well at low speeds. This resulted in tons of sludge everywhere from the oil pan to the rocker arms. Newer engines with a PCV valve almost always look clean inside by comparison. But like you said it's all part of the learning experience.

I really like your truck, keep up the good work!