The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

merlin3 · 05-21-2013, 05:19 AM

thanks for the help.i hope i am doing this right,i put a level on the floor and make sure it is level,i measured from the level to the front of frame and the driver side is a 1/4 inch lower than pass side..both upper and lower bump stops are new on both sides,not sure on the stance before i did the install it has been so long,it has been a year to figure this front end out. there is no nose on the truck as of now.i took another measurement and the diff in the bump stops on both sides is 5/8 of an inch.i think if i get the truck on the frame machine and chain down the frame just behind the suspension and pull up on the front frame end the 1/4 inch will be 5/8 of a inch to the suspension area.

05-21-2013, 05:19 AM	#3
merlin3 Registered User Join Date: Aug 2012 Location: nantucket,ma Posts: 230	Re: wrong coil spring? thanks for the help.i hope i am doing this right,i put a level on the floor and make sure it is level,i measured from the level to the front of frame and the driver side is a 1/4 inch lower than pass side..both upper and lower bump stops are new on both sides,not sure on the stance before i did the install it has been so long,it has been a year to figure this front end out. there is no nose on the truck as of now.i took another measurement and the diff in the bump stops on both sides is 5/8 of an inch.i think if i get the truck on the frame machine and chain down the frame just behind the suspension and pull up on the front frame end the 1/4 inch will be 5/8 of a inch to the suspension area.