View Single Post
Old 05-22-2013, 01:44 AM   #20
JJorgensen52
Simple? What's simple?
 
JJorgensen52's Avatar
 
Join Date: Apr 2007
Location: Southeast CT
Posts: 1,472
Re: '72 C3500 GMC flatbed project

Progress has been slow. I've found a good SM465 PTO, I've been working on the hydraulics slowly but surely, but mostly I've been worrying about trailer wiring.




Rear lighting back in place and with sufficient slack to let the bed tilt fully



Bulkhead connector I'm mounting to the firewall for all the trailer brake wiring




You may notice some other terminals in the background - I'm tapping into the factory harness at the rear harness firewall connector and the stop lamp switch, replacing the terminals and using wire from another harness I cut up, so in essence it will look as if the factory installed the plug in connector for a brake controller inside the cab.
__________________
CURRENT
'50 GMC 100 shortbed Gen IV 4.8 LS - 4L65E (Secret truck, Shhh!!!) Build
'63 Buick Wildcat Coupe 401ci Nailhead (Very much in pieces) Photos
'66 Impala SS convertible 327-QJet-glide (4 speed swap one of these days...) Photos
'69 CST/10 4x4 SWB Stepper 350 2bbl - NV4500/NP241C (Broken Truck!)
'72 Sierra Grande 2WD LWB fleetside 350-TH350 Refresh
'99 K2500 Silverado RCLB 5.7 Vortec - NV4500/NP241C (Daily)
'99 K2500 Suburban 7.4 Vortec - NV4500/NP246 (still working out the bugs)
SOLD
'71 Custom/10 2WD LWB fleetside - '72 GMC K/3500 Dually (Sold to redryder)
JJorgensen52 is offline   Reply With Quote