1. Center punch and drill 6 (or less, however many you think is necessary
) .125" holes and install screws (I used phillips head #10? I think) They are the only holes that you can see the green paint on the tin.
2. Remove 3 1/4" hex head screws used for alignment. (one is still in place in the pic. woops.)
3. Install light bulbs. These are the originals but you will need wired light sockets of the same size.
4. Place the S10 speedo assembly onto the plate.
5. Place the clear S10 lens over and install the T15 Torx screws from the back side.