[kyhillbilly]

I have another question. I know I'm pestering you guys to death but I don't have anyone else to ask.

I am going to replace all of the brake lines on this truck. Currently, the lines come out of the master cylinder and run down to the frame. The line to the rear brakes goes to the front of the truck, crosses over to the passenger side (underneath the radiator support) and down the length of the frame to the rear-end, where it meets the flex line over to the rear-end and from there to each wheel cylinder. My question is this. Would it make a major difference if I ran the rear brake line down the driver's side of the frame? I could save on the amount of brake line needed by doing this, but I don't want to do it if it's going to be unsafe in any way. Thanks guys.