View Single Post
Old 06-02-2013, 05:05 PM   #3
OrrieG
Registered User
 
OrrieG's Avatar
 
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
Re: whats the thread size for the steering shaft?

Glove box to hinge looks like a 10-32 x 3/8" shoulder screw. My taps only go to 1/2 is, steering column center bolt looks like 9/16 NF threads jamp type nut (thinner then regular) BUT it might even be finer threads. I would get it in a grade 8 since it has to pull the wheel down on the shaft threads. Aftermarket nut was probably made off shore, I've had problems with them too cross threading or being just enough off to mess up the threads.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread
1964 Chevelle Malibu w/ 355-350TH (daily driver)
Helpful AD and TF Manual Site Old Car Manual Project
OrrieG is offline   Reply With Quote