|
Re: 69 Custom 30 wrecker restoration
I also started on the rear tail panel. I cut the old one off with the plasma cutter and made up a new blank panel from two pieces of 11 gauge sheet and used a piece of angle for the bottom. Once all welded up, I got to use my handy dandy Eastwood circle cutter guide for the plasma cutter to cut out the 6 holes for the tail light housings. It worked quite well and I can’t even imagine how I would have tackled this without the plasma cutter.
__________________
Bob
63 Impala 283/PG/3.36 (under restoration)
66 Impala 327/PG/3.36
66 Chevelle SS 409/M22/3.55
69 Chevelle 307/PG/3.08 (future restoration)
69 C10 short stepside 454/TH350/3.73
69 Custom 30 tow truck 350/4 spd/4.10 (resto done, CRUISIN TIME!)
71 Cheyenne 20 fleetside 350/4 spd/4.10
71 Chevelle 6/PG/3.08
72 Chevelle 454/M21/4.10
Last edited by bobs409; 07-01-2013 at 07:26 AM.
|