The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

xpickup · 07-07-2013, 11:34 AM

Oldman3, thank you.

48 GMC BURB, thank you, yes we had a good time. I will figure out the steering shaft later today.

Off to a late start today. I talked to Trently(aussie54) for a few hours this morning so I an a little behind. Then it got hot. I did manage to pull the bed off and cut out the bad and plug weld the lower front tube on the front panel. Now off to the pool with the family for a little while and then back at it later when it cools down.

Shannon
Posted via Mobile Device
Posted via Mobile Device
Posted via Mobile Device

07-07-2013, 11:34 AM	#21
xpickup Registered User Join Date: Jan 2007 Location: York, Pa. Posts: 1,386	Re: 1951 Chevy / C4 Oldman3, thank you. 48 GMC BURB, thank you, yes we had a good time. I will figure out the steering shaft later today. Off to a late start today. I talked to Trently(aussie54) for a few hours this morning so I an a little behind. Then it got hot. I did manage to pull the bed off and cut out the bad and plug weld the lower front tube on the front panel. Now off to the pool with the family for a little while and then back at it later when it cools down. Shannon Posted via Mobile Device Posted via Mobile Device Posted via Mobile Device Attached Images __________________ 48 Panel Truck 1948 Chevy / S10 1954 Chevy / S10 1951 Chevy / C4 47 Step van Lowered 1996 Dually