|
Couldn't you put a square on the axle flange hubs (a plumb bob would work better). Mark the floor & measure the distance between. It would be hard to mark the pumpkin, so then measure & mark 1/4's on the axle housing from each half.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|