The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

66Submarine · 08-08-2013, 04:34 PM

I guess it's a 3/4-1 ton? I think cab and chassis dually rear ends are about the right width, might look at those. A C&C 14 bolt is 63.5" WMS-WMS, I think the factory Eaton SRW is 65". SRW 14 bolt is 67.5", if that works. (My stepside isn't wide enough, but a fleetside should be.)

08-08-2013, 04:34 PM	#5
66Submarine Registered User Join Date: Sep 2012 Location: Dallas, GA Posts: 1,497	Re: narrowing a dana 60 I guess it's a 3/4-1 ton? I think cab and chassis dually rear ends are about the right width, might look at those. A C&C 14 bolt is 63.5" WMS-WMS, I think the factory Eaton SRW is 65". SRW 14 bolt is 67.5", if that works. (My stepside isn't wide enough, but a fleetside should be.)