Quote:
Originally Posted by keithcorcoran
thanks for the info.
i almost feel like if you're going to do ans IFS up front and nothc the frame you might as well try to find a bagged s10 and do the frame swap.
that's probably because i don't know too much about it but if you're going to go that far with it.. might as well.
i DID see the drop axle writeup on sid's site.. that doesn't look too bad.
not quite as easy as hacking off a couple of turns on a coil spring but not too terrible.
thanks for the info.. i'll start doing some research.
|
If your looking to bag a 47-55 1st series Porterbuilt fabrication is coming out with a kit that's going to involve all c10 spindles. Nate posted a pick on Instagram last week that showed it might be a trailing arm kit in the rear and a dropmember up front. Top notch!!
Posted via Mobile Device