Jim, yes those measurements will help. I looked over your build and I see that you went with lower truss brackets. My mockup motor/tranny is a 5.3 with a 700r4 case and from everthing I have read that combo should have plenty of clearance against the floor board, unlike your 4L80. This picture is another forum members set-up and his tranny crossmember is mounted at the very bottom of the frame. I would have to have mine at the very top and still possibly have to install some spacers to reach.
I have a phone call and email in to PB, so I am interested in what the say.
Thanks, John
Quote:
Originally Posted by jtp67-72
here's mine with camaro pan and rack installed..i'm out of town but can measure mine mon.......jim
|